Creating The Mcc Unit - Siemens SIMOTION SCOUT Configuration Manual

Configuring/parameterizing
6.6 Programming the SIMOTION application
6.6.2.2

Creating the MCC unit

Procedure
To insert an MCC source, proceed as follows:
1. Open the PROGRAMS folder below the SIMOTION device in the project navigator.
2. Double-click
The Insert MCC source dialog opens.
Figure 6-27
3. Assign a name, motion in the example.
4. Go to the Compiler tab. For diagnostics purposes, activate the options Permit program
status and Permit single step. In this way, you can monitor program execution later in online
mode.
5. Click OK to confirm.
114
Insert MCC source.
Inserting an MCC source
SIMOTION SCOUT
Configuration Manual, 11/2016