Siemens SIMOTION SCOUT Configuration Manual page 108

Configuring/parameterizing
6.5 Creating and testing an axis
Assume control priority
To assume control priority, proceed as follows:
1. Show the control area by clicking the
traversing motions in this mode.
2. Show the diagnostic area by clicking the
are caused by the motion commands sent to the axis in this mode.
3. Select the axis that you want to traverse and monitor from the selection list, PLC_1 -
Axis_1 in the example.
4. Specify the parameters you want to display in the lower left side of the Diagnostics area
using the selection lists. The corresponding values are shown next to them.
5. Select Assume control priority to establish the connection to the PG/PC.
The Assume control priority dialog opens.
Figure 6-25
6. Observe the safety regulations and confirm with Accept.
The PG/PC has the control priority; the button caption has changed to Return control priority.
Note
By pressing the SPACEBAR, you can stop the axis at any time.
108
Assume control priority
button in order to test, for example, programmed
button in order to test traversing motions that
SIMOTION SCOUT
Configuration Manual, 11/2016