Scrapping Method; Precautions On Return Of Product; Note; Returning Procedure - EBARA EV-A03 Instruction Manual

The pump main body and peripheral units may have been polluted by hazardous substances depending
on each applied process.
Perform scrapping in compliance with the safety control standards of the nation and each local self-
governing body.
10.1 Notes
When returning the pump and peripheral units to us for an overhaul, repair, etc. be sure to clarify
the applied gas and products. This is duty-bound by the Industrial Safety and Health Law.
Before returning a unit, fill the Return Notice Sheet attached to this manual with necessary contents
and submit it by FAX or mail. The user may have to return it to the approved dealer depending on the
applied gas. The above request will lead to a smooth repair or overhaul.
If this sheet is not submitted, the returned product may be regarded as a hazardous substance and
be rejected.

10.2 Returning Procedure

For a return, observe the following procedure.
1) Copy the Return Notice Sheet attached at the end of this manual and fill it with necessary contents.
2) Operate the pump while charging inert gas such as N2 gas to remove toxic gas and corrosive gas
completely from the pump. For the peripheral unit to be returned, eliminate toxic gas by charging inert
gas. When solutions and lubricating oil can be disposed of properly on the user side, bleed them
completely.
3) Remove all the accessories which are attached to the equipment.
4) Seal up the inlet port and outlet port of the pump by using blank flanges.
5) Seal up the product to be returned if possible after putting them in a polyethylene case or
polyethylene sheet.
6) When returning the pump or unit, put the product to be returned on a wood pallet with a size of 510
mm x 915 mm or less and fix it with bands. In case of a large product which cannot be put on such a
pallet, please ask us for information.
7) If the product to be returned is not so large as being fixed on a pallet, pack it in a solid case.
8) If the product to be returned is polluted, observe the law related to the transportation of hazardous
substances, and stick a label having an indication to this effect on a pallet or case.
9) Submit the Return Notice Sheet filled with necessary contents to us by FAX or mail. This Return
Notice Sheet should reach us earlier than the product to be returned.
10) Hand over a copy of the Return Notice Sheet to the forwarding agent. If the product to be returned is
polluted, be sure to inform the forwarding agent of this effect.
11) Put the original of the Return Notice Sheet into an envelope and stick it on the outside of the product
to be returned.
PM10U

9. SCRAPPING METHOD

10. PRECAUTIONS ON RETURN OF PRODUCT

P.45
EBARA
CORPORATION