Pitney Bowes SV62214 Operator's Manual page 129

10 • Maintenance
Replacing the Print Head
9. Remove the protective tape or the black cap from the bottom of the
replacement print head.
Protective Tape
10. Squeeze the two gray tabs on either side of the new print head
and slightly angle the print head while pushing the print head
flush against the wall.
11. If you are using the same ink cartridge you removed in Step 5,
continue with step 12.
Otherwise, if you are putting in a new ink cartridge, remove the
new ink cartridge from the bag. The tape should pull off (remove
if necessary).
10-10
OR
Black Cap
Flush Against Wall
Tabs
SV62214 Rev. A