For Serial Interface (Rs-232C) - Dascom DT-210 User Manual

Tally Dascom DT-210/230
4.
Replace the DIP switch cover, and screw it in place.
New DIP switch settings are enabled after the printer is turned on!

5.2 For Serial Interface (RS-232C)

When using the built-in USB interface, it is not necessary to change the DIP switch setting but their
function changes. For the details, see
DIP Switches Bank 1
SW
1-1 Auto Line Feed at CR
1-2 Handshaking
1-3 Data Length
1-4 Parity Check
1-5 Parity Selection
Baud Rate Selection
1-6
1-7
(bps)
1-8
Transmission Speed
Transmission Speed (bps: bits per second)
2400
4800
9600
19200 (default)
38400
57600
115200
Note: Depending on print conditions, such as print duty, print head temperature, and data
transmission speed, print speed is automatically adjusted, which can cause white lines due to
intermittent print (the motor sometimes stops). To avoid this, set the transmission speed higher or
keep the print speed constant by setting it lower.
DIP Switches Bank 2
SW
2-1 Reserved
2-2 Internal bell control
2-3 Auto Cutter
"For Parallel and USB2.0
Function
Function
Interface" .
ON
Enable
XON/XOFF
7bits
Yes
EVEN
See the "Transmission
1-6
ON
OFF
OFF
OFF
OFF
ON
ON
-
Internal bell disable
Disable
49
User Guide V1.3
OFF
Disable
DTR/DSR
8bits
No
ODD
Speed" table below
1-7 1-8
OFF
OFF
ON
ON
OFF
OFF
ON
OFF ON
ON
OFF
-
Internal bell enable
Enable
Initial
setting
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF
Initial
setting
OFF
OFF
OFF