Table of Contents
Advertisement
Tally Dascom DT-210/230
The commands listed below in the first column are defined as "obsolete commands" in the ESC/POS
command system.
This printer supports both upward-compatible commands and obsolete commands. However, the
upward-compatible commands are recommended to use.
Obsolete command
ESC i
Partial cut (one point left uncut)
ESC m Partial cut (three points left uncut)
ESC u
Transmit peripheral device status
ESC v
Transmit paper sensor status
FS p
Print NV bit image
FS q
Define NV bit image
GS v 0 Print raster bit image
"Obsolete commands" are commands that are supported by legacy models;
however it is recommended to replace them with upward-compatible commands,
because they will not be supported in the future products.
Upward-compatible command
GS V
GS V
GS r
GS r
GS ( L <Function 69>
GS ( L <Function 67>
GS ( L <Function 112 + 50>
85
User Guide V1.3
Advertisement
Table of Contents
Need help?
Do you have a question about the DT-210 and is the answer not in the manual?
Questions and answers