Dascom DT-210 User Manual page 33

Tally Dascom DT-210/230
2.
The interface is pre-set with the IP address 192.168.0.31. DHCP is disabled. Enter this IP address
in your browser to get access to the built in web page.
Item
Information
Configuration
Network
3.
Click Configuration→Network→TCP/IP, the default setup for getting IP address is manual, you
can start setting the IP address, subnet mask and default gate way.
Item
Get IP Address
IP Address
Subnet Mask
Default Gateway
4.
If you want to enable DHCP mode, select "Auto" in Get IP address option.
Or you can do this by pressing the reset button next to the RJ45 socket while you switch on your
printer.
Verify the new setting by pressing the button after some seconds again. The new IP address is
being printed.
General
TCP/IP
TCP/IP
Reset Reset the ETH01 or return to the factory default
Explanation
Show the method of setting the IP address
Show the IP address
Show the subnet mask of the IP address
Show the default gateway
Explanation
Show the ETH01 information
Show the TCP/IP information
Set the TCP/IP information
setting
28
User Guide V1.3