YASKAWA SI-P3 Installation Manual page 29

Note: Depending on the drive model, some drives may require replacing the front cover of the drive
after routing the wiring to the outside. In these cases, use diagonal cutters to cut out the
perforated openings in the right side of the drive front cover and leave no sharp edges to damage
wiring.
The drive will not meet IP20 conformity if wiring is exposed outside the enclosure.
Perforated
openings cut out
Right side of the drive front cover
10.
Set drive parameters in
parameter F6-30 to a node address unique to the network.
YASKAWA ELECTRIC TOBP C730600 82B YASKAWA AC Drive Option SI-P3 Installation Manual
Cut out here.
Route the wiring and connector to the outside.
Table 8 for proper option performance. Be sure to set
5 Installation Procedure
29