YASKAWA SI-P3 Installation Manual page 43

Keypad Display
EF0
Cause
An external fault was received
from the PLC.
Problem with the PLC program. Check the PLC program.
Keypad Display
oFA00
Cause
The option card installed into
port CN5-A is incompatible
with the drive.
Keypad Display
oFA01
Cause
The option connected to option
port CN5-A was changed
during run.
Keypad Display
to
oFA30 to
oFA43
Cause
The option card connection to
port CN5-A is faulty.
Keypad Display
oFb00
Cause
The option card installed into
port CN5-A is incompatible
with the drive.
YASKAWA ELECTRIC TOBP C730600 82B YASKAWA AC Drive Option SI-P3 Installation Manual
Option Card External Fault
The alarm function for an external device has been triggered.
1. Remove the cause of the external fault.
2. Reset the external fault input from the PLC.
Option Card Connection Error (CN5-A)
Option is not properly connected.
Connect the option to the correct option port.
Note: Connect the SI-P3 to CN5-A. For other option connections, refer to the
Installation Manual for those options.
Option Card Fault (CN5-A)
Option is not properly connected.
De-energize the drive and plug the option into the drive according to
Procedure on page 14.
Option Card Connection Error (CN5-A)
Communication ID error.
1. Turn off the power.
2. Check if the option is properly plugged into the option port.
3. Replace the option if the fault continues to occur.
Option Fault (CN5-B)
Non-compatible option is connected.
Connect the option to the correct option port.
Note: Use connector CN5-B when connecting DO-A3, AO-A3, or two PG options.
Use connector CN5-C when connecting only one PG option.
8 Troubleshooting
Fault Name
Possible Solution
Fault Name
Possible Solution
Fault Name
Possible Solution
Fault Name
Possible Solution
Fault Name
Possible Solution
Installation
43