YASKAWA SI-P3 Installation Manual page 23

Install the Option
n
Remove the front cover of the drive before installing the option. Refer to the drive
instruction manual for directions on removing the front cover. Cover removal varies
depending on drive size. This option can be inserted only into the CN5-A connector located
on the drive control board.
DANGER! Electrical Shock Hazard. Do not inspect, connect, or disconnect any wiring while the drive is
energized. Failure to comply will cause death or serious injury. Before servicing, disconnect all power to the
equipment and wait for at least the time specified on the warning label. The internal capacitor remains
charged even after the drive is de-energized. The charge indicator LED will extinguish when the DC bus
voltage is below 50 Vdc. When all indicators are OFF, measure for unsafe voltages to confirm the drive is
safe.
1.
Affix the LED label (E) in the appropriate position on the drive front cover (D).
Figure 11
YASKAWA ELECTRIC TOBP C730600 82B YASKAWA AC Drive Option SI-P3 Installation Manual
Figure 11 Affix the LED Label
5 Installation Procedure
E
D
A1000
23