Table of Contents
Advertisement
11. CHARACTERISTICS
11. CHARACTERISTICS
11.1 Overload protection characteristics
An electronic thermal relay is built in the drive unit to protect the servo motor and drive unit from
overloads.
Overload 1 alarm (A.50) occurs if overload operation performed is above the electronic thermal relay
protection curve shown in any of Figs. 13.1, or overload 2 alarm (A.51) occurs if the maximum current
flows continuously for several seconds due to machine collision, etc. Use the equipment on the left-hand
side area of the continuous or broken line in the graph.
In a machine like the one for vertical lift application where unbalanced torque will be produced, it is
recommended to use the machine so that the unbalanced torque is 70% or less of the rated torque.
The overload protection characteristic is about 20% lower than that of the MELSERVO-J2-Super series.
However, operation at the 100% continuous rating can be performed.
1000
100
10
During servo lock
1
0.1
0
50
100
a. MR-J2M-10DU to MR-J2M-40DU
Note. If operation that generates torque more than 100% of the rating is performed with an abnormally high frequency in a servo motor stop
status (servo lock status) or in a 30r/min or less low-speed operation status, the servo amplifier may fail even when the electronic
thermal relay protection is not activated.
During rotation
150
200
250
(Note) Load ratio [%]
Fig 11.1 MR-J2M multiple axis overload curve
www.dadehpardazan.ir 88594014-15
1000
100
During servo lock
10
1
0.1
300
0
50
11 - 1
During rotation
100
150
200
(Note) Load ratio [%]
b. MR-J2M-70DU
250
300
Hide quick links:
Advertisement
Table of Contents
