Tektronix SPG8000 Technical Reference page 63

EMBED button menu (Option SDI only)
Status. Use this menu item to set the status of the individual audio channel. Use
the left (◄) or right (►) arrow button to select between Active, Inactive, and
Mute. Press the ENTER button to confirm the selection.
Frequency. Use this menu item to set the frequency of the Embedded Audio signal
from 10.0 Hz to 20 kHz, in steps of 0.5 Hz. Press the ENTER button to enter the
adjustment mode, then use the left (◄) and right (►) arrow buttons to position
the cursor, and then use the up (▲) and down (▼) arrow buttons to set the number
for that position. Press the ENTER button again to confirm the new frequency.
Amplitude. Use this menu item to set the audio amplitude from –60 dBFS to
0 dBFS, in steps of 1 dBFS. Use the left (◄) and right (►) arrow buttons to set
the amplitude, and then press the ENTER button to confirm the selection.
Audio Click. Use this menu item to set the audio click rate to one click every
one, two, three, or four seconds, or turn the click off. Use the left (◄) or right
(►) arrow button to select the click rate, and then press the ENTER button to
confirm the selection.
Channel Origin. Use this menu item to set a channel origin ID of up to four
ASCII characters. Press the ENTER button, and then use the left (◄) and right
(►) arrow buttons to position the cursor, and then use the up (▲) and down
(▼) arrow buttons to set the ID. Press the ENTER button to confirm the new
Channel Origin ID.
SPG8000 Technical Reference 51