Tektronix SPG8000 Technical Reference page 144

SYSTEM button menu
132
NETWORK. Displays or sets the current network parameters of the
10/100/1000 BASE-T port on the instrument. Use the left (◄) or right (►) arrow
button to toggle between the following two selections:
Information. Select Information and press the ENTER button to access the
NETWORK INFO submenu. (See page 138.)
Setup. Select Setup and press the ENTER button to access the NET SETUP
submenu. (See page 139.)
SNMP. Enables or disables SNMP (Simple Network Management Protocol), and
configures up to four IP addresses to receive SNMP traps. Select this menu item
and then press the ENTER button to access the SNMP submenu. (See page 140,
SNMP submenu.)
WEB USER INTERFACE. Disables or sets the control limits for the SPG8000 Web
User Interface (See page 9, Web user interface.). Use the left (◄) or right (►)
arrow button to select between the following options. Press the ENTER button to
confirm the selection.
Full-Control. Allows a user to have full control of instrument settings when
using the Web User Interface.
Disable. Disables the instrument from being accessed by the Web User
Interface.
Read-Only. Allows a user to have read-only access to instrument settings
when using the Web User Interface.
USB <status>. Displays the current status of the USB port:
Not Connected is displayed when no USB drive is connected to the
instrument.
Not Mounted is displayed when a USB drive is connected to the instrument
but is not mounted. Press the ENTER button to mount the drive. Normally, a
USB drive will automatically mount when connected to the instrument.
Mounted is displayed when a USB drive is connected to the instrument and
is mounted. Press the ENTER button to safely unmount the drive. The
message You May Now Safely Remove USB Drive appears when it is safe
to remove the drive.
CAUTION.
To prevent the loss of data on the USB drive, be sure to unmount the
USB drive before you remove the drive from the instrument.
BACKUP/RESTORE. Backs up or restores the instrument presets or all user data
using a USB drive. Use the left (◄) or right (►) arrow button to select the type
of backup or restore operation, and then press the ENTER button to perform the
operation. (See page 15, How to backup/restore presets and user data.)
SPG8000 Technical Reference