Tektronix SPG8000 Technical Reference page 187

SPG8000 Technical Reference
PROGRAM TIME. Applies the initial program time configured in the INITIAL
TIME menu item below. Select this menu item and press the ENTER button
to apply the configured Initial Time.
NOTE.
You can use the INPUT TRIGGER setting in the SYSTEM : GPI submenu
to configure pin 4 of the GPI port connector to trigger the instrument to reset the
program time. (See page 147, GPI submenu.)
INITIAL TIME. Enters the initial program time. Select this menu item and press
the ENTER button to edit the Initial Time setting.
Use the left (◄) or right (►) arrow button to select a digit in the Program Time
counter to change. An underline character appears under the selected digit. The
date and time digits take the following form: HH:MM:SS.
After you select a digit, use the up (▲) or down (▼) arrow button to change
the value of the digit. Repeat for each digit as required. Press the ENTER to
confirm the change.
ALARM. Enables or disables the Alarm Time function. Use the left (◄) or right
(►) arrow button to select Enabled or Disabled. Press the ENTER button to
confirm the selection.
ALARM TIME. Enters the Alarm Time schedule setting. Using the GPI connector,
the Alarm Time function can be used to drive a light or similar indicator of alarm
occurrences at a specific time in a program. Select this menu item and press the
ENTER button to edit the Alarm Time.
Use the left (◄) or right (►) arrow button to select a digit in the Alarm Time
schedule to change. An underline character appears under the selected digit. The
date and time digits take the following form: HH:MM:SS.
After you select a digit, use the up (▲) or down (▼) arrow button to change
the value of the digit. Repeat for each digit as required. Press the ENTER to
confirm the setting.
NOTE.
You can use the SYSTEM : GPI OUTPUT submenu to configure the GPI
port connector to output a signal when the Alarm Time setting is reached. (See
page 149, GPI OUTPUT <1, 2, or 3> submenu.)
TIME button menu
175