Usb Port Configuration - Advantech B+B SmartWorx LR77 v2 Configuration Manual

3.21 USB Port Configuration
You can use a USB to RS232 converter to send data out of the serial port from the Ethernet
network in the same manner as the RS232 expansion port function. To specify the values for
the USB port parameters, click USB Port in the Configuration section of the main menu. The
following tables describe the parameters available in the configuration form.
Item Description
Baudrate Applied communication speed.
Data Bits Number of data bits.
Parity Control parity bit:
Stop Bits Number of stop bit.
Split Timeout Time to rupture reports. If the gap between two characters exceeds
the parameter in milliseconds, any buffered characters will be sent
over the Ethernet port.
Protocol Communication protocol:
Mode Mode of connection:
Server Address When set to TCP client above, it is necessary to enter the Server ad-
dress and TCP port.
TCP Port TCP/UDP port used for communications. The router uses the value
for both the server and client modes.
Inactivity Timeout Time period after which the TCP/UDP connection is interrupted in
case of inactivity.
none – data will be sent without parity.
even – data will be sent with even parity.
odd – data will be sent with odd parity.
TCP – communication using a linked protocol TCP.
UDP – communication using a unlinked protocol UDP.
TCP server – The router will listen for incoming TCP connection
requests.
TCP client – The router will connect to a TCP server on the
specified IP address and TCP port.
Table 67: USB Port Configuration 1
100
3. CONFIGURATION