Switch Between Sim Cards Configuration - Advantech B+B SmartWorx LR77 v2 Configuration Manual

Item
Roaming State
Data Limit State
BIN0 State
Table 22: Switch between SIM cards configuration
Use the following parameters to specify the decision making of SIM card switching in the
cellular module.
Item
Default SIM Card
Continued from previous page
Description
Configure the use of SIM cards based on roaming. This roaming
feature has to be activated for the SIM card on which it is enabled!
not applicable – It is possible to use the SIM card every-
where.
home network only – Only use the SIM card if roaming is
not detected.
Configure the use of SIM cards based on the Data Limit set
above:
not applicable – It is possible to use the SIM regardless of
the limit.
not exceeded – Use the SIM card only if the Data Limit (set
above) has not been exceeded.
Configure the use of SIM cards based on binary input 0 state.
This option is not available on Libratum versions of the routers.
not applicable – It is possible to use the SIM regardless of
BIN0 state.
on – Only use the SIM card if the BIN0 state is logical 1 –
voltage present.
off – Only use the SIM card if the BIN0 state is logical 0 –
no voltage.
Description
Specifies the modules' default SIM card. The router will attempt
to establish a connection to mobile network using this default.
1st – The 1st SIM card is the default.
2nd – The 2nd SIM card is the default.
32
3. CONFIGURATION
Continued on next page