Wifi Configuration - Advantech B+B SmartWorx LR77 v2 Configuration Manual

3.5 WiFi Configuration
This item is available only if the router is equipped with a WiFi module.
Configure the WiFi network by selecting the WiFi item in the main menu of the router web
interface. Activate WiFi by selecting Enable WiFi at the top of the form. You may set the
following properties listed in the table below.
RADIUS (Remote Authentication Dial-In User Service) networking protocol that provides cen-
tralized Authentication, Authorization, and Accounting (AAA) management for users is sup-
ported on WiFi. The router can be RADIUS client only (not the server) – typically as a WiFi
AP (Access Point) negotiating with the RADIUS server. In WiFi STA (Station) operating mode
the authentication method EAP-PEAP/MSCHAPv2 (both PEAPv0 and PEAPv1) is supported
only.
Item
Operating mode
SSID
Broadcast SSID
Probe Hidden
SSID
Description
WiFi operating mode:
access point (AP) – The router becomes an access point to
which other devices in station (STA) mode can connect.
station (STA) – The router becomes a client station. It re-
ceives data packets from the available access point (AP) and
sends data from cable connection via the WiFi network.
The unique identifier of WiFi network.
Method of broadcasting the unique identifier of SSID network in bea-
con frame and type of response to a request for sending the beacon
frame.
Enabled – SSID is broadcasted in beacon frame
Zero length – Beacon frame does not include SSID. Requests
for sending beacon frame are ignored.
Clear – All SSID characters in beacon frames are replaced
by 0. Original length is kept. Requests for sending beacon
frames are ignored.
Probes hidden SSID (only for station (STA) mode)
38
3. CONFIGURATION
Continued on next page