Wlan Configuration - Advantech B+B SmartWorx LR77 v2 Configuration Manual

3.6 WLAN Configuration
This item is available only if the router is equipped with a WiFi module.
The WiFi LAN and DHCP server page is displayed by selecting WLAN in the configuration
section. You will then be able to set the following properties (see table below). Use the Enable
WLAN interface check box at the top of this form to enable WiFi LAN interface.
Item
Operating Mode
DHCP Client
IP Address
Subnet Mask
Bridged
Default Gateway
DNS Server
Description
WiFi operating mode:
access point (AP) – The router becomes an access point
to which other devices in station (STA) mode can be con-
nected.
station (STA) – Router becomes a client station. It will re-
ceive data packets from the available access point (AP) and
send data from cable connection via the WiFi network.
Activates/deactivates DHCP client.
Fixed set IP address of WiFi network interface.
Subnet mask of WiFi network interface.
Activates bridge mode:
no – Bridged mode is not allowed (default value). WLAN
network is not connected with LAN network of the router.
yes – Bridged mode is allowed. WLAN network is connected
with one or more LAN networks of the router. In this case,
the setting of most items in this table are ignored. Instead,
the router uses the settings of the selected network interface
(LAN).
IP address of the default gateway. When entering the IP address
of the default gateway, all packets for which the record was not
found in the routing table will be sent to this address.
Address to which all DNS
Table 27: WLAN Configuration
44
3. CONFIGURATION
queries are forwarded.