Pptp Tunnel Configuration - Advantech B+B SmartWorx LR77 v2 Configuration Manual

3.14 PPTP Tunnel Configuration
PPTP is an unencrypted protocol.
Select the PPTP item in the menu to configure a PPTP tunnel. PPTP tunnel allows pass-
word protected connections between two LANs. It is similar to L2TP. The tunnels are active
after selecting Create PPTP tunnel.
Item
Mode
Server IP Address
Local IP Address
Remote IP Address
Remote Subnet
Remote Subnet Mask
Username
Password
The changes in settings will apply after pressing the Apply button.
The firmware also supports PPTP passthrough, which means that it is possible to create a
tunnel through the router.
Description
Specifies the L2TP tunnel mode on the router side:
PPTP server – Specify an IP address range offered by
the server.
PPTP client – Specify the IP address of the server.
IP address of the server.
IP address of the local side of the tunnel.
IP address of the remote side of the tunnel.
Address of the network behind the remote side of the tunnel.
The mask of the network behind the remote side of the tunnel
Username for the PPTP tunnel login.
Password for the PPTP tunnel login.
Table 44: PPTP Tunnel Configuration
Figure 42: PPTP Tunnel Configuration
75
3. CONFIGURATION