Firewall Configuration; Filtering Of Incoming Packets - Advantech B+B SmartWorx LR77 v2 Configuration Manual

3.8 Firewall Configuration
The first security element which incoming packets pass is a check of the enabled source
IP addresses and destination ports. You can specify the IP addresses as an IP address from
which you can remotely access the router and the internal network connected behind a router.
To enable this function, marking the Enable filtering of incoming packets check box located
at the top of the Firewall Configuration page. Accessibility is checked against the IP address
table. This means that access is permitted only to addresses specified in the table. It is pos-
sible to specify up to eight remote IP addresses for access. You can specify the following
parameters:
Item Description
Source IP address from which access to the router is allowed.
Protocol Specifies the protocol used for remote access:
Target Port The port number on which access to the router is allowed.
Action Specifies the type of action the router performs:
The next section of the configuration form specifies the forwarding policy. If you unmark
the Enabled filtering of forwarded packets check box, then packets are automatically accepted.
If you activate this function, and a packet is addressed to another network interface, then the
router sends the packet to the FORWARD chain. When the FORWARD chain accepts the
packet and there is a rule for forwarding it, the router sends the packet. If a forwarding rule is
unavailable, then the router drops the packet.
This configuration form also contains a table for specifying the filter rules. It is possible
to create a rule to allow data with the selected protocol by specifying only the protocol, or to
create stricter rules by specifying values for source IP addresses, destination IP addresses,
and ports.
all – Access for all protocols is active.
TCP – Access for the TCP protocol is active.
UDP – Access for the UDP protocol is active.
ICMP – Access for the ICMP protocol is active.
allow – The router allows the packets to enter the network.
deny – The router denies the packets from entering the network
Table 31: Filtering of Incoming Packets
49
3. CONFIGURATION