Sending Sms; Send Sms On Ethernet Port1 Configuration - Advantech B+B SmartWorx LR77 v2 Configuration Manual

Setting the parameters in the Enable AT-SMS protocol over TCP frame, you can enable
the router to send and receive SMS messages on a TCP port. This function requires you to
specify a TCP port number. The router sends SMS messages using a standard AT command.
Item Description
TCP Port TCP port on which will be allowed to send/receive SMS messages.
Table 61: Send SMS on ethernet PORT1 configuration

3.19.1 Sending SMS

If you establish a connection to the router using a serial interface or Ethernet, then you can
use AT commands to manage SMS messages. The following table lists only the commands
that the router supports. For other AT commands the router sends an OK response. The
router sends an ERROR response for complex AT commands.
AT Command Description
AT+CGMI Returns the specific identity of the manufacturer.
AT+CGMM Returns the specific model identity of the manufacturer.
AT+CGMR Returns the specific model revision identity of the manufacturer.
AT+CGPADDR Displays the IP address of the usb0 interface.
AT+CGSN Returns the product serial number.
AT+CIMI Returns the International Mobile Subscriber Identity number (IMSI).
AT+CMGD Deletes a message from the location.
AT+CMGF Sets the presentation format for short messages.
AT+CMGL Lists messages of a certain status from a message storage area.
AT+CMGR Reads a message from a message storage area.
AT+CMGS Sends a short message from the device to entered tel. number.
AT+CMGW Writes a short message to the SIM storage.
AT+CMSS Sends a short message from the SIM storage location.
AT+COPS? Identifies the mobile networks available
AT+CPIN Used to query and enter a PIN code.
AT+CPMS Selects the SMS memory storage types, to be used for short message
operations.
AT+CREG Displays network registration status.
AT+CSCA Sets the short message service center (SMSC) number
AT+CSCS Selects the character set.
3. CONFIGURATION
Continued on next page
90