Table 2-40 Rsp Tab Configuration Parameters - Honeywell UMC800 Reference Manual

Function Blocks
2.50 PID Function Block,
Configuration Parameters, continued
RSP TAB
It looks like this graphically on the Control Builder. Table 2-40 describes the parameters and the value or
selection.
Properties Group Parameter
Remote Setpoint
Source and Input (EU)
Units
Use LSP2
Ratio/Bias No Ratio or
(RSP Input
Use Local
Only)
Local Bias
Value (EU)
144
continued

Table 2-40 RSP Tab Configuration Parameters

Index#
N/A
Use RSP
Use RSP
Input (%)
(EU)
N/A
Bias
Bias
Use Bias
Input
40
39
Ratio
Function Block Reference Guide
Parameter Description
Use Remote Setpoint in
Engineering Units
Use Remote Setpoint in
Percent
Use Local Setpoint #2 in
Engineering Units
No ratio and bias applied
to the function block
Use Bias value selected
on Tab
Use Bias value attached
to an input to the block
Local bias value in
engineering units
Gain value for Ratio PID
Value or Selection
Click on radio button to select
Click on radio button to select
Click on radio button to select
Click on radio button to select
Click on radio button to select
Enter value at "Local Bias
Value" on tab.
Click on radio button to select
Enter local bias value
-99999 to 99999
-20 to +20
3/99