Honeywell UMC800 Reference Manual page 153

2.50 PID Function Block,
Table 2-39 General Tab Configuration Parameters, continued
Properties Group Parameter
Start/Restart Initial Mode
Failsafe Out Failsafe Out
3/99
continued
Index#
N/A
N/A
Power Up
Mode
N/A
Power Up
Out
16
Function Block Reference Guide
Parameter
Description
Control Mode and
MAN LSP Manual control and
Setpoint at
NEWSTART
AUTO LSP Automatic control and
Newstart is the first
scan cycle following
the cold start of the AUTO RSP Automatic control and
controller
Man LSPonly Manual control
Auto LSPonly Automatic control
Auto RSPonly Automatic control
*These modes will override the
configured POWER UP MODE.
Control Mode and
MAN LSP Manual control and
Setpoint at power up
AM LSP
AM LR
Output at Power up
LAST OUT Same as at power
FAILSAFE Failsafe output value.
Failsafe Output Value
-5 to 105%
Function Blocks
Value or Selection
last local
setpoint
last local .
setpoint
remote .
setpoint
and local
setpoint
only.
and local
setpoint
only*.
and remote
setpoint
only*.
last local
setpoint
Same control mode
(auto or manual) and
last local .
setpoint
Same control mode (auto
or manual) and setpoint
(local or remote) as at
power-down.
down.
Continued next page
143