Honeywell UMC800 Reference Manual page 192

Function Blocks
2.60 SPP Function Block,
Output
SP = Programmed
AUX = Second non-ramping auxiliary setpoint output in engineering units. (For example, see
subsection 2.60.4.)
STMR = Time Remaining in current segment - in minutes.
STME = Time Elapsed in current segment - in minutes.
PTME = Time Elapsed in program - in minutes
GHOLDI = Guaranteed soak hold indication - turns on if PV is outside guaranteed soak
band and Guaranteed Soak is enabled.
READY = Program Reset state indication
HOLDI = Program Hold state indication
RUNI = Program Run state indication
STOPI = Program Stop indication (Program Complete)
PGM = Current Profile Number (1 to 70) - connect to PGM input on SPEV block.
SEG = Current Segment Number (1 to 50) - connect to SEG input on SPEV block.
STA = Current program state (RESET, HOLD, RUN, GHOLD, STOP). Connected to STA input of
the SPEV block
ATTENTION
ATTENTION — The program states are:
0 = Until block is first executed after power up
1 = Reset
2 = Hold
3 = Run
4 = GHold
5 = Stop
182
continued
value in engineering units
setpoint
Function Block Reference Guide 3/99