Cleaning Drop-In Refrigeration Assembly Condenser Coil; Checking Ice Water Bath; Cleaning Water Tank - Cornelius VANTAGE Installation Manual

CLEANING DROP-IN REFRIGERATION ASSEMBLY CONDENSER COIL

(see Figure 4)
CAUTION: The refrigeration assembly condenser coil must be cleaned every 30-days.
Excessive accumulation of dust, lint, and grease on the condenser coil will restrict air flow
through the coil and cause the refrigeration system to overheat. Operating the refrigeration
system in an overheated condition will eventually lead to compressor failure and will automatically
void the factory warranty.
Clean the drop-in refrigeration assembly coil as follows:
1. Unplug Unit power cord from the electrical outlet.
2. Remove screw securing the hood, then lift the hood straight up to remove.
3. Vacuum or use a soft brush to clean the condenser coil. If available, use low-pressure compressed air.
4. Clean dust and dirt from around top of the drop-in refrigeration assembly.
5. Install hood on the Unit and secure with screw.
6. Plug Unit power cord into electrical outlet. The refrigeration system will start after a 2-minute time delay.

CHECKING ICE WATER BATH

(see Figure 4)
A ' ' gurgle' 'heard from the Unit indicates water level in the water tank is low and more water should be added for
maximum cooling. Before adding more water, check the ice water bath for cleanliness and check the water tank
coils for excessive mineral deposit build-up.
1. Unplug Unit power cord from electrical outlet.
2. Remove screw securing the hood, then lift the hood straight up to remove.
3. Lift insulation pad covering front section of the water tank for visual inspection of the ice water bath and
the ice bank.
4. Using a flashlight, inspect the ice water bath and ice bank for cleanliness. The ice water bath should be
clear and the ice bank should be free of foreign particles.
5. If cleaning of the water tank is necessary, refer to CLEANING WATER TANK in this section.
6. Fill the water tank with clean water until water begins to run out of the overflow tube into the drip tray. USE
LOW-MINERAL-CONTENT WATER WHERE A LOCAL WATER PROBLEM EXISTS.
7. Lower the insulation pad into proper position on top of the water tank.
8. Install Unit hood and secure with screw.
9. Plug Unit power cord into electrical outlet. The refrigeration system will start after a 2-minute time delay.

CLEANING WATER TANK

(see Figure 4)
1. Unplug the Unit power cord from electrical outlet.
2. Remove two screws securing the Unit front access panel, then remove the panel.
3. Extend the water tank drain hose (located on front of Unit) to a waste container or floor drain. Remove plug
from end of the drain hose and allow the water tank to drain.
560001790
20