ROUTING AND CONNECTING PRODUCT INLET LINES
(see Figures 2, 3, and 4)
1. Route product inlet lines (numbered for identification) up over edge of the countertop behind the Unit or up
through hole cut in the countertop underneath the Unit. Route product inlet lines up to a point behind the
Unit front access panel close to the barbed product inlet connections on the Unit.
NOTE: The Unit barbed product inlet lines connections to the dispensing valves are labeled to identify
the dispensing valve they serve. For example: the line labeled ' ' 1' 'must be connected to system that
provides product to be dispensed from NO.1 dispensing valve. (NO. 1 dispensing valve is the valve on
right side when facing front of Unit.)
IMPORTANT
TO THE INSTALLER: DO NOT CUT CLAMPS SECURING
BARBED FITTINGS ON ENDS OF THE UNIT PRODUCT
INLET CONNECTIONS.
2. Connect product inlet lines to the barbed product inlet connections on the Unit. Secure connections with
tubing clamps.
3. All access holes to inside of the Unit base must be closed and sealed.
INSTALLING DISPENSING VALVES KNOBS
(see Figure 4)
1. Install dispensing valves knobs (LOOSE-SHIPPED with the Unit) on the dispensing valves.
CONNECTING CO
2
(see Figure 2)
WARNING: CO
CO
(carbon dioxide) gas leaks in the entire CO
2
suspected, particularly in a small area, immediately ventilate the contaminated area before
attempting to repair the leak. Personnel exposed to high concentration of CO
tremors which are followed rapidly by loss of consciousness and suffocation.
WARNING: To avoid personal injury and/or property damage, always secure CO
upright position with a safety chain to prevent it from falling over. Should valve become
accidentally damaged or broken off, CO
1. Position CO
cylinder in upright position and secure with safety chain.
2
FIGURE 3. UNIT PRODUCT INLET CONNECTIONS
GAS LINES TO PRODUCT TANKS
displaces oxygen. Strict attention must be observed in the prevention of
2
and soft drink system. If a CO
2
cylinder can cause serious personal injury.
2
9
gas leak is
2
gas will experience
2
cylinder in
2
5600001790