If ink drainage was not performed when transporting by LEVEL 0 or 1, remove the belt stopper and attach the power cord and interface cable after moving the

printer to the installation location, and then check the operation of the printer (with test pattern).

2. Installing after transporting by LEVEL 2 or LEVEL 3.

If ink drainage was performed when transporting by LEVEL 2 or LEVEL 3, follow the installation procedure which is nearly identical to the procedure when in-

stalling for the first time.

See "Installation" > "Unpacking and Installation" for the installation procedure.

Be sure to place the printer on the stand by lifting installation. Tipping installation should not be performed.

3-56

Table of Contents