031A1002-2905/031A1002-2906 Hard Disk Preservation Error; 031A1001-2908/031A1006-2909 Hard Disk Error; 03130031-2F13 A/D Converter External Trigger Output Stopped; 03130031-2F14 Asic Register Cannot Be Written - Canon iPF9000 series Service Manual

6.1.3.42 031A1002-2905/031A1002-2906 Hard disk preservation error

iPF9000
<Cause>
The job preservation was executed when the permanent preservation area of the hard disk (private box) has no extra preservating spaces.
The job preservation was executed when the permanent preservation area of the hard disk (private box) has already preserved one-hundred jobs.
<Probable fault location>
Operation method, hard disk drive, main controller PCB
<Countermeasure>
1) Delete preserved jobs in the permanent preservation area of the hard disk (private box).
2) Replace the hard disk drive.
3) Replace the main controller PCB.

6.1.3.43 031A1001-2908/031A1006-2909 Hard disk error

iPF9000
<Cause>
The format of the hard disk was damaged.
The files preserved in the hard disk was damaged.
<Probable fault location>
Hard disk drive, main controller PCB
<Countermeasure>
1) Replace the hard disk drive.
2) Replace the main controller PCB.

6.1.3.44 03130031-2F13 A/D Converter external trigger output stopped

iPF9000
<Cause>
Defective main controller PCB
<Probable fault location>
Main controller PCB
<Countermeasure>
1) Turn off the printer, and then turn it off again.
2) Replace the main controller PCB.

6.1.3.45 03130031-2F14 ASIC Register cannot be written.

iPF9000
<Cause>
A main controller PCB firmware error occurred.
<Probable fault location>
Main controller PCB
<Countermeasure>
1) Turn off the printer, and then turn it on again.
2) Replace the main controller PCB.
6.1.3.46 03900001-4042/03900001-4049 Firmware error
iPF9000
<Cause>
Firmware cannot be recognized.
The firmware is for another model.
<Probable fault location>
Firmware or main controller PCB
<Countermeasure>
1) Firmware
Check the version of the transferred firmware and the compatible models.
2) Replace the main controller PCB.

6.1.3.47 E194-4034 Sensor calibration error

iPF9000
<Cause>
When executing [SERVICE MODE] > [ADJUST] > [SENSOR CALIB.], multi sensor calibration could not be done.
<Probable fault location>
Test chart, multi sensor, main controller PCB
<Countermeasure>
1) Test chart
Check the test chart. if there is a problem, exchange it.
Chapter 6
0012-6962
0014-2772
0013-7238
0013-7240
0014-2788
0014-9355
6-13