[3] When printing on large and stiff sheets, or when the Media Take-up Unit is used, or when the Output Stacker is stored for long periods, lower it to this position

for storage.

When using the Output Stacker again after storage, reattach the Basket Rod on the front of the Output Stacker to the tips of the left and right Basket Rods and pull

the side rods out completely.

[4] When printing banners or when printing on delicate paper, set it to this position.

- When storing printed documents on the Output Stacker, always use it in position [1]. If you do not, printed documents may not be dropped into the Output Stacker,

and the printed surface may become soiled.

- The Output Stacker can hold one sheet. When printing multiple pages, remove each sheet after it is printed.

- Before using the Output Stacker, remove the Rewind Spool. If you do not, it may prevent printed documents from being held correctly, and it they may be

scratched.

a. Using the Output Stacker in the position for ejection in the front of the printer

You can also set the Output Stacker to the following position when printing banners or when printing on delicate paper.

MEMO:

- Always choose [Cutting Mode] > [Eject] in the main menu when the Output Stacker is in the position for ejection in the front of the printer. If you choose [Auto-

matic], printed documents may be damaged.

- During ejection in the front of the printer, be especially careful when using delicate paper or paper that curls easily.

- With some types of paper, the leading edge may curl or bend during ejection. In this case, straighten out the paper. Printed documents may be damaged if the paper

is curled or bent.

- Some types of paper may get caught between the Ejection Guide and Output Stacker during ejection. In this case, free the paper from where it is caught. Printed

documents may be damaged if the paper gets caught.

[2]

[1]

[3]

F-1-25

[4]

[2]

[1]

[3]

F-1-26

[4]

Chapter 1