Canon iPF9000 series Service Manual page 63

[Adjust Printer]
[Auto Head Adj.]
[Manual Head Adj]
[Auto Band Adj.]
[Manual Band Adj]
[Adjust Length]
[Interface Setup]
[EOP Timer]
[TCP/IP]
[NetWare]
[AppleTalk]
[Ethernet Driver]
[Init. Settings]
[Maintenance]
Setting Item
[Maint. cart.]
[Replace P.head]
[Repl. S. Cleaner]
[Change Cutter]
[Move Printer]
Setting Item
[Standard Adj.]
[Advanced Adj.]
[Auto Print]
[Standard Adj.]
[Advanced Adj.]
Setting Item
[TCP/IP]
[IP Mode]
[Protocol] [DHCP]
[BOOTP]
[RARP]
[IP Setting] [IP Address]
[Subnet Mask]
[Default G/W]
[NetWare]
[Frame Type]
[Print Service]
[Auto Detect]
[Comm.Mode]
[Ethernet Type]
[Spanning Tree]
[MAC Address]
When replacing the Maintenance Cartridge, choose Yes and follow the instructions on the screen.
Not displayed during a warning message that the remaining Maintenance Cartridge capacity is low.
When replacing the Printhead, choose Yes and follow the instructions on the screen.
When replacing the Shaft Cleaner, choose Yes and follow the instructions on the screen.
When replacing the Cutter Unit, choose Yes and follow the instructions on the screen.
You can also reset the cut counter after the Cutter Unit is replaced.
When transferring the printer to another location, choose the level of transfer and follow the instructions on
the screen.
Description, Instructions
Choose Yes to have the printer print and read a test pattern for the automatic
adjustment of Printhead alignment relative to the printing direction.
Choose Yes to have the printer print and read a test pattern for the automatic
adjustment of Printhead alignment relative to the nozzle and printing direction.
Choose On to have the printer automatically execute the Advanced Adj. operations
after you replace the Printhead.
Choose Yes to print a test pattern for adjustment of Printhead alignment relative to
the printing direction. Enter the adjustment value manually based on the resulting
pattern.
Choose Yes to have the printer print and read a band adjustment test pattern for
automatic adjustment of the feed amount.
Choose this option when using paper other than genuine Canon paper, or paper for
purposes other than checking output.
Choose Yes to have the printer print and read a band adjustment test pattern for
automatic adjustment of the feed amount. Note that this function takes more time
and requires more ink than Standard Adj.
Choose Yes to print a test pattern for adjusting the feed amount based on the paper
type.
Choose Yes to print a test pattern for adjustment relative to paper stretching or
shrinkage, after which you can enter the amount of adjustment.
Description, Instructions
Specify the timeout period before cancellation of print jobs that cannot be
received by the printer.
Specify the TCP/IP protocol settings. To apply your changes, choose Register
Setting.
Choose whether the printer IP address is configured automatically or a static IP
address is entered manually.
Specify the protocol used to configure the IP address automatically.
Specify the printer network information when using a static IP address.
Enter the IP address assigned to the printer, as well as the network subnet mask
and default gateway.
Specify the NetWare protocol. To apply your changes, choose Register Setting.
Specify the frame type to use.
Choose the print service.
Specify whether to use the AppleTalk protocol. To apply your changes, choose
Register Setting.
Specify the communication method. To apply your changes, choose Register
Setting.
Choose On for automatic configuration of the LAN communication protocol.
Choose Off to use settings values of Comm.Mode and Ethernet Type.
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported over the LAN.
Displays the MAC address.
Execute? is displayed if you press the
network settings to the default values.
Description, Instructions
Chapter 1
button. Choose OK to restore the
1-47