Table of Contents
Advertisement
Chapter 3
2) Insert hands in the holes in the front side of the bottom cardboard seat to hold the printer, and turn the printer 90 degrees backward until it lies on its back on the
cushioning material for printer installation.
3) Turn and remove the joints from the bottom cardboard seat, and then remove the stand support cardboard.
4) Remove the cushioning materials from the stand connection areas.
MEMO:
Do not cut the black packing belts. If you do so, you cannot install the printer with it turned over.
3-14
F-3-26
F-3-27
F-3-28
F-3-29
Advertisement
Table of Contents
Troubleshooting
