Table of Contents
Advertisement
Chapter 4
1) To remove left/ right tank cover unit [1] , remove three screws [2], open tank cover [3] and remove two hooks [4].
j) Ink tank units
Opening the ink tank units
1) To open the left/right ink tank units, remove left/ right circle cover (L), left/ right circle cover (S), left/ right side covers, upper left/ right cover and left/ right
tank cover unit.
2) Remove two screws [1].
3) Remove screw [3] from the support plate[2] at inner side of the printer.
4) Remove screw [4] from the support plate[3] at outer side of the printer, loosen screw [5] and slide the support plate to open the ink tank unit.
The ink tank units will lock themselves when they are opened to the maximum allowable angle.
Be sure to open the ink tank unit to their maximum allowable angle to prevent them from turning over.
k) Upper rear cover
Removing the upper rear cover
1) To remove the upper rear cover, remove left/ right circle cover (L), left/ right circle cover (S), left/ right side covers , upper left/upper right cover, rear cover,
right/ middle/ left , and left/ right tank cover units and then open the left/ right ink tanks.
4-10
[1]
[2]
[2]
F-4-18
[3]
[5]
[2]
F-4-19
[3]
[4]
[1]
Advertisement
Table of Contents
Troubleshooting
