Table of Contents
Advertisement
Axis Series – RX User Guide
Software v2.0 and above
Screenshot: Scan Settings Pane
Step 3: Start the Scan
1. Click the Start button.
2. The Confirm Scan message window opens. This reminds you normal operations will
stop.
CAUTION: This means the receiver will drop any channel it is receiving. Don't run a scan if
the receiver is on air!
3. Click the OK button.
4. Observe the graphical display of the scan. The orange line will track across the graph
drawing a graph of RF power levels. The state indicator shows scanning.
5. You can click the Pause button at any time. Click Continue button to carry on with the
scan.
6. After the scan, there is a testing phase – please wait until this is complete.
Revision 2.5
February 2015
Figure 6-36 Scan Settings Pane
User Guide – Ver. 2.5
Page 6-92
Advertisement
Table of Contents
