Wave Central Axis Series User Manual page 54

Axis Series – RX User Guide
Software v2.0 and above
No Name
2 Battery
Voltage
3 Case
Temperature
4 GPS Data
5 GPS Data
Step 7: Interpret the Service 1 Pane
Screenshot: Service 1 Pane
Figure 6-9 Input Sub-Tab showing Service 1 Pane
No Name
1 Service Name
Revision 2.5
February 2015
Options Notes
Any voltage on a This field reports the current voltage of the
green or red field transmitter's battery in VDC.
background.
If the field background is green, the voltage
is greater than the TX Battery Alarm voltage
parameter specified in the Global Settings
pane.
If the background shows red, then the
voltage is below the alarm limit, too low
and the unit will fail to operate correctly.
Any temperature This field reports the current temperature of
on a green or red the transmitter's case in degrees Celsius.
field background.
Locked or No Indicates if GPS Data is being sent from the
transmitter. If GPS NMEA data is present,
the receiver will extract and display it.
Locked in this case This shows the Transmitter 1 Pane with
GPS data being received.
Table 6-5 – Transmitter 1 Pane Key
Options Notes
H.264 Unit 1 is This text box lets you name the multicast
default but could stream as delivered in the SAP/SDP packets
be anything. from the unit. Default is H.264 Unit 1.
The Service Name on the receiver should
match the transmitter's service name.
User Guide – Ver. 2.5
Page 6-51