Table of Contents
Advertisement
Axis Series – RX User Guide
Software v2.0 and above
No
Name
4
DVBT Carrier
Mode
5
ASI Output
6
Remux Input
7
Remux Bitrate
Revision 2.5
February 2015
Options
2K or 4K
5.00
User Guide – Ver. 2.5
Notes
If you selected DVBT as your Modulation
Type earlier, you can now select how
many carriers will be used.
2K=About 2000
4K=About 4000 (dual pedestal mode)
The source for the ASI output is selected
here.
For example if you choose Demod 1,
then this will provide an ASI signal to the
ASI Out port.
If you choose Remux, the ASI Output will
be made up of whatever you configure in
the next field, Remux Input.
This field enables you to select what you
want to go into the Remux. You can
combine sources to be remuxed into a
single ASI stream.
For example, Demod 1+ASI in would
enable you to have received pictures
being combined with a signal from the
ASI input port, all being sent to the ASI
Output port.
For correct operation all PIDs present in
the input streams must be unique.
If you have selected Remux in ASI
Output (item 5 in this table) earlier,
then this field will become active and will
enable you to set the bitrate for the
Remux stream leaving the ASI Output
port.
You may have remuxed two video
signals together which you are then
planning to transmit forwards. You could
configure the Remux Bitrate to suit your
transmitter bandwidth then ensure the
two signals you are going to Remux will
fit into that space.
For correct operation, the bitrate must
be equal or higher than the combined
bitrate of all input streams.
Page 6-80
Advertisement
Table of Contents
