Wave Central Axis Series User Manual page 37

Axis Series – RX User Guide
Software v2.0 and above
Step 2: Configure the IP Settings Pane - Gateway
For multicast operations it is very important that you configure the gateway in the IP
settings pane even though we might not have a gateway in our network.
1. You must use an IP address in the same network range as the AXRX1 and for simplicity;
we recommend you use the actual AXRX1 IP Address for your Gateway too.
Figure 5-4 Configure the Gateway in the IP Settings Pane
Step 3: Configure the Streaming Settings
1. Check the Streaming Enable checkbox.
2. In the Streaming Mode box select UDP Multicast.
3. In the Streamer Select box choose the source you want to stream (Demod 1 in my
example).
4. In the Multicast Address box set 239.16.33.254.
5. In the Multicast TTL box set 10.
6. In the Multicast Port box set 10000.
7. In the Multicast Service Name box set 10000.
8. In the Multicast ToS box set Routine (0).
9. Click the Apply button.
10. The Configured Successfully message opens.
11. Click the OK button.
Revision 2.5
February 2015
User Guide – Ver. 2.5
Page 5-34