ZOLL E Series Service Manual page 62

E Series Service Manual
Error Message
INSERT CARD
Check memory card
LOW BATTERY
NO QRS DETECT
NO SHOCK ADV
NOISY ECG
OPEN AIR DISCHARGE
PACER DISABLED
PACER FAULT 115
PACER FAULT 116
PACER FAULT 117
PACER FAULT 121
PACER FAULT 122
PACER FAULT 123
PACER FAULT 126
2-10
Explanation
No card installed in unit during manual or semi-automated
modes.
Low battery.
Unit is in sync mode and heart rate is < 20 BPM or QRS
amplitude is too low for proper synchronization.
No shock advised. Advisory message when analysis finds
non-shockable rhythm.
Number of noisy analysis intervals exceeds threshold.
Cap voltage too high after discharge attempt, e.g., full
energy discharge did not occur.
User prompt issued simultaneously with other pace faults
if pacing is disabled.
Flyback pulse width control circuit is not under proper
control of the processor and gate array.
Failure to detect XPACE_ON.
Pace relay is stuck closed.
During pace, the pace pulse width <30ms or >50ms.
Pace current is more than 15mA above and below
selected value.
Measured pace rate is too fast compared to selected rate.
Issued in conjunction with message 122. Pace current is
more than 15mA and below selected value.
User Technical Action
Advisory


Replace battery or plug into AC power. Replace
charger.

Increase ECG size and/or change lead.


Stop all patient movement. Check connections.
Press Analyze button again.
Replace paddles, and, or high voltage module and
system board.
Replace high voltage module or system board.
Replace high voltage module, capacitor, or
system board.
Replace high voltage module, capacitor, and/or
system board.
Replace high voltage module, capacitor, and/or
system board.
Replace high voltage module, or system board.
Replace high voltage module, or system board.
Replace high voltage module or system board.
Replace high voltage module.
9650-1450-01 Rev. D