Tire Is Flat Or Will Not Hold Air; Safety Shutdown At Building Entrance - Segway PT x2 Reference Manual

Tire is Flat or Will Not Hold Air

One of the Tires on your Segway PT is flat or will not hold air.
You should review the following service procedure prior to
troubleshooting this problem for important instructions: "Checking
Tire Inflation Pressure" on page 104.
Recommended Action:
1. Check for Tire damage. If the Tire is damaged, contact an
Authorized Segway Dealer or Distributor to order a replacement
Tire/Wheel Assembly.
2. If there is not visible Tire damage, check to make sure the Tire
valve stem core is tight. Tighten the valve stem if necessary.
3. Inflate the Tire and check for leaks. If the Tire goes flat or will not
maintain inflation pressure, contact an Authorized Segway
Dealer or Distributor to order a replacement Tire/Wheel
Assembly.

Safety Shutdown At Building Entrance

Theft detection systems, such as the type used in some libraries and
retail stores can interfere with the Segway PT's ability to balance and/
or cause the Segway PT to perform a Safety Shutdown. Do not ride
within 5 feet (1.5 meters) of any theft detection system. These
systems may not always be visible.
Recommended Action:
1. Step off at least 5 feet (1.5 meters) away from theft detection
systems and walk through the theft detection system in Standby
Mode or with the Segway PT powered off.
2. Once you are at least 5 feet (1.5 meters) away from the theft
detection system, return to Balance Mode and step on.
127