Attaching The Leansteer Frame - Segway PT x2 Reference Manual

Attaching the LeanSteer Frame

Tool Required: Torque wrench with 5mm bit.
To attach the LeanSteer Frame to the Powerbase:
1. Make sure the Segway PT is unplugged and powered off.
2. Slide the LeanSteer Frame onto the Pivot Base Assembly, as
shown in Figure 31:
Pivot Base Assembly
Figure 31. Attach Handlebar/LeanSteer Frame to the Pivot Base
3. If the Wedge Clamps are not installed, install each Wedge
Clamp, curved side facing down, on either side of the LeanSteer
Frame base.
4. Loosely thread in the fastener.
96
Assembly
LeanSteer Frame