Table of Contents
Advertisement
1.
Make sure the Segway PT is unplugged and powered off.
2.
Reseat one of the Batteries on the Powerbase with curved edge
facing out, as shown in Figure 36.
Figure 36. Reattaching the Batteries
3.
Ensure the Battery is aligned straight against the edge of the
Powerbase trim, and there are no uneven gaps.
4.
Install and tighten the 2 center fasteners with the 3mm hex
wrench to 1.0 N-m (9 in-lbf)
5.
Install and tighten the 2 outer fasteners with the 3mm hex wrench
to 1.0 N-m (9 in-lbf)
6.
Ensure the Battery is aligned straight against the edge of the
Powerbase trim, and there are no uneven gaps.
7.
Repeat Steps 1 through 7 for the second Battery.
103
Hide quick links:
Advertisement
Table of Contents
