Simrad GO XSE Installation Manual page 49
Hide thumbs
Also See for GO XSE:
- Operator's manual (204 pages) ,
- Installation manual (84 pages) ,
- Getting started (41 pages)
Table of Contents
Advertisement
Calibrate
Calibration may be required to accurately match measured flow
with actual fuel flow. Access calibration from the Refuel dialog.
Calibration is only possible on Navico's Fuel Flow sensor.
1.
Start with a full tank and run the engine as it would normally be
operated.
2.
After at least several liters (a few gallons) have been used, the
tank should be fully refilled, and the Set to full option selected.
3.
Select the Calibrate option.
4.
Set the actual amount used based on amount of fuel added
to the tank.
5.
Select OK to save settings. The Fuel K-Value should now show
a new value.
Software Setup
| GO XSE Installation Manual
49
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the GO XSE and is the answer not in the manual?
Questions and answers