Autopilot Setup; Fuel Setup - Simrad GO XSE Installation Manual

Choose from Local interference rejection LOW, MED or HIGH.
Default is LOW.
Restore radar to factory defaults
This option can be used to revert all user adjustments.

Autopilot setup

For setup and commissioning of autopilot computers, refer to the
documentation included with your autopilot system or autopilot
computer.

Fuel setup

The fuel utility monitors a vessel's fuel consumption. This
information is totaled to indicate trip and seasonal fuel usage, and is
used to calculate fuel economy for display on instrument pages and
the data bar.
To use the utility, a Navico Fuel Flow sensor, or a NMEA 2000 engine
adaptor cable/gateway with Navico Fuel Data Storage device must
be fitted to the vessel. Neither the Navico Fuel Flow sensor, nor the
Suzuki engine interface require the use of a separate Fuel Storage
device. Refer to the engine manufacturer or dealer for information
on whether or not your engine provides a data output, and what
adaptor is available to connect to NMEA 2000.
Once the physical connection is made, ensure source selection is
completed. Multiple engine installations using Fuel Flow sensors, or
Fuel Data Storage devices, require setup of related engine location
in the Device list. For general source selection information, refer to
"Data source selection" on page 33.
Vessel setup
The Vessel setup dialog must be used to select the number of
engines, the number of tanks and vessel's total fuel capacity across
all tanks.
47
Software Setup | GO XSE Installation Manual