HP 10500 Series Configuration Manual page 75

[Switch] domain default enable bbb
c. Configure 802.1X authentication:
# Enable 802.1X globally.
[Switch] dot1x
# Enable 802.1X for port GigabitEthernet 1/0/1.
[Switch] interface gigabitethernet 1/0/1
[Switch-GigabitEthernet1/0/1] dot1x
[Switch-GigabitEthernet1/0/1] quit
# Configure the access control method. (Optional. The default setting meets the requirement.)
[Switch] dot1x port-method macbased interface gigabitethernet 1/0/1
4. Verify the configuration:
NOTE:
If the user host runs the Windows XP 802.1X client, you must select the Enable IEEE 802.1X
•
authentication for this network option and select MD5 challenge as the EAP authentication type on the
Authentication tab of the connection's properties.
If the user host runs the HP iNode client, no advanced authentication options need to be enabled.
•
When using the HP iNode client, the user can pass authentication after entering username
dot1x@bbb and the correct password in the client property page. When using the Windows XP
802.1X client, the user can pass authentication after entering the correct username and password
in the pop-up authentication page. After the user passes authentication, the server assigns the port
connecting the client to VLAN 4.
Use the display connect command to view the connection information on the switch.
[Switch] display connection
Slot: 1
Index=22 , Username=dot1x@bbb
IP=192.168.1.58
IPv6=N/A
MAC=0015-e9a6-7cfe
Total 1 connection(s) matched on slot 1.
Total 1 connection(s) matched.
# View the information of the specified connection on the switch.
[Switch] display connection ucibindex 22
Slot: 1
Index=22 , Username=dot1x@bbb
MAC=0015-e9a6-7cfe
IP=192.168.1.58
IPv6=N/A
Access=8021X
Port Type=Ethernet,Port Name=Gigabitethernet 1/0/1
Initial VLAN=2, Authorized VLAN=4
ACL Group=Disable
User Profile=N/A
CAR=Disable
Priority=Disable
Start=2009-04-26 19:41:12 ,Current=2009-04-26 19:41:25 ,Online=00h00m14s
,AuthMethod=CHAP
65