Displaying And Maintaining Fips; Fips Configuration Example - HP 10500 Series Configuration Manual

Task
2. Trigger a self-test.

Displaying and maintaining FIPS

Task
Display FIPS mode state.

FIPS configuration example

Network requirements
PC connects to Switch through a console port. Configure Switch to operate in FIPS mode and create a
local user for PC so that PC can log in to the switch.
Figure 113 Network diagram
Configuration procedure
1. Configure Switch:
# Enable the FIPS mode.
<Sysname> system-view
[Sysname] fips mode enable
# Enable the password control function.
[Sysname] password-control enable
# Create a local user named test, and set its service type to terminal, privilege level to 3, and
password to AAbbcc1234%. The password must contain at least 10 characters by default and
must contain both uppercase and lowercase letters, digits, and special characters. Configure the
password in interactive mode.
[Sysname] local-user test
[Sysname-luser-test] service-type terminal
[Sysname-luser-test] authorization-attribute level 3
[Sysname-luser-test] password
Password:***********
Confirm :***********
Updating user(s) information, please wait...........
[Sysname-luser-test] quit
# Save the configuration.
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Command
fips self-test
Command
display fips status
297
Remarks
Disabled by default.
Remarks
Available in any view.