HP 10500 Series Configuration Manual page 291

Figure 111 Network diagram
Configuration procedure
1. Configure IP addresses of the hosts as shown in
2. Configure the IP address of GigabitEthernet 1/0/1 on the gateway.
<Gateway> system-view
[Gateway] interface gigabitethernet 1/0/1
[Gateway-GigabitEthernet1/0/1] ip address 10.1.1.100 24
3. Configure Switch A:
# Configure manual-mode MFF.
[SwitchA] vlan 100
[SwitchA-vlan-100] mac-forced-forwarding default-gateway 10.1.1.100
# Specify the IP address of the server.
[SwitchA-vlan-100] mac-forced-forwarding server 10.1.1.200
# Enable ARP snooping.
[SwitchA-vlan-100] arp-snooping enable
[SwitchA-vlan-100] quit
# Configure GigabitEthernet 1/0/2 as a network port.
[SwitchA] interface gigabitethernet 1/0/2
[SwitchA-GigabitEthernet1/0/2] mac-forced-forwarding network-port
4. Configure Switch B:
# Configure manual-mode MFF.
[SwitchB] vlan 100
[SwitchB-vlan-100] mac-forced-forwarding default-gateway 10.1.1.100
# Specify the IP address of the server.
[SwitchB-vlan-100] mac-forced-forwarding server 10.1.1.200
# Enable ARP snooping.
[SwitchB-vlan-100] arp-snooping enable
[SwitchB-vlan-100] quit
# Configure GigabitEthernet 1/0/6 as a network port.
[SwitchB] interface gigabitethernet 1/0/6
[SwitchB-GigabitEthernet1/0/6] mac-forced-forwarding network-port
Figure 111.
281