HP 10500 Series Configuration Manual page 189

Figure 74 Network diagram
Configuration procedure
The following configuration steps cover some AAA/RADIUS configuration commands. For more
information about the commands, see Security Command Reference.
Configuration procedures for the host and RADIUS servers are not shown.
Configuration on the device:
1. Configure the RADIUS protocol:
# Configure a RADIUS scheme named radsun.
<Device> system-view
[Device] radius scheme radsun
[Device-radius-radsun] primary authentication 192.168.1.2
[Device-radius-radsun] primary accounting 192.168.1.3
[Device-radius-radsun] secondary authentication 192.168.1.3
[Device-radius-radsun] secondary accounting 192.168.1.2
[Device-radius-radsun] key authentication name
[Device-radius-radsun] key accounting money
[Device-radius-radsun] timer response-timeout 5
[Device-radius-radsun] retry 5
[Device-radius-radsun] timer realtime-accounting 15
[Device-radius-radsun] user-name-format without-domain
[Device-radius-radsun] quit
# Configure ISP domain sun to use RADIUS scheme radsun for authentication, authorization, and
accounting of all types of users. Specify that the ISP domain can contain up to 30 users.
[Device] domain sun
[Device-isp-sun] authentication default radius-scheme radsun
[Device-isp-sun] authorization default radius-scheme radsun
[Device-isp-sun] accounting default radius-scheme radsun
[Device-isp-sun] access-limit enable 30
[Device-isp-sun] quit
2. Configure 802.1X:
# Set the 802.1X authentication method to CHAP. (This configuration is optional. By default, the
authentication method is CHAP for 802.1X.)
[Device] dot1x authentication-method chap
3. Configure port security:
# Enable port security.
[Device] port-security enable
179