HP 10500 Series Configuration Manual page 71

Log in to IMC, click the Service tab, and select User Access Manager > Access Device
Management > Access Device from the navigation tree. Then, click Add to configure an access
device as follows:
a. Set the shared key for secure authentication and accounting communication to expert.
b. Set the ports for authentication and accounting to 1812 and 1813, respectively.
c. Select LAN Access Service as the service type.
d. Select HP(General) as the access device type.
e. Select the access device from the device list, or manually add the device with the IP address
10.1.1.2.
f. Leave the default settings for other parameters, and click OK.
NOTE:
The IP address of the access device specified here must be the same as the source IP address of the RADIUS
packets sent from the switch, which is chosen in the following order on the switch:
• The IP address specified with the nas-ip command.
The IP address specified with the radius nas-ip command.
•
The IP address of the outbound interface (the default).
•
Figure 26 Adding the switch as an access device
# Add a charging plan.
Click the Service tab, and select Accounting Manager > Charging Plans from the navigation tree to
enter the charging plan configuration page. Then, click Add to configure a charging plan as
follows:
a. Add a plan named UserAcct.
b. Select Flat rate as the charging template.
c. Select time for Charge Based on, select Monthly for Billing Term, and enter 120 in the Fixed Fee
field.
d. Enter 120 in the Usage Threshold field and select hr for the in field to allow the user to access
the Internet for up to 120 hours per month.
e. Leave the default settings for other parameters and click OK.
61