When The Switch Acts As An Sftp Client For Publickey Authentication - HP 10500 Series Configuration Manual

b. Enter username client002 and password aabbcc as prompted to log in to the SFTP server.
Figure 90 SFTP client interface
When the switch acts as an SFTP client for publickey
authentication
Network requirements
As shown in
B acts as the SFTP server, adopting publickey authentication and the RSA public key algorithm.
Figure 91 Network diagram
Configuration procedure
In the server configuration, the client public key is required. Use the client software to generate RSA key
pairs on the client before configuring the SFTP server.
1. Configure the SFTP client:
# Create VLAN-interface 2 and assign an IP address to it.
<SwitchA> system-view
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ip address 192.168.0.2 255.255.255.0
[SwitchA-Vlan-interface2] quit
# Generate the RSA key pairs.
[SwitchA] public-key local create rsa
Figure 91, you can log in to Switch B through the SFTP client that runs on Switch A. Switch
231