HP 10500 Series Configuration Manual page 63

Set the shared keys for secure RADIUS communication to expert. Set the ports for
authentication/authorization and accounting to 1812 and 1813, respectively.
Figure 15 Network diagram
Configuration procedure
1. Configure IP addresses for the devices as shown in
reach each other. (Details not shown.)
2. Configure the RADIUS server (when the server runs on IMC PLAT 5.0):
NOTE:
This section assumes that the RADIUS server runs on IMC PLAT 5.0 (E0101H03) and IMC UAM 5.0 SP1
(E0101P03).
# Add the switch to the IMC Platform as an access device.
Log in to IMC, click the Service tab, and select User Access Manager > Access Device
Management > Access Device from the navigation tree. Then, click Add to configure an access
device as follows:
a. Set the shared key for secure authentication and accounting communication to expert.
b. Set the ports for authentication and accounting to 1812 and 1813, respectively.
c. Select LAN Access Service as the service type.
d. Select HP(General) as the access device type.
e. Select the access device from the device list, or manually add the device with the IP address
10.1.1.2.
f. Leave the default settings for other parameters, and click OK.
NOTE:
The IP address of the access device specified here must be the same as the source IP address of the RADIUS
packets sent from the switch, which is chosen in the following order on the switch:
The IP address specified with the nas-ip command.
•
• The IP address specified with the radius nas-ip command.
The IP address of the outbound interface (the default).
•
Figure 15
53
and make sure that devices can