When The Switch Acts As An Stelnet Server For Publickey Authentication - HP 10500 Series Configuration Manual

Figure 80 Specifying the host name (or IP address)
c. Click Open to connect to the server.
If the connection is successfully established, the system asks you to enter the username and
password. After entering the username (client001) and password (aabbcc), you can enter the
command-line interface of the server.
When the switch acts as an Stelnet server for publickey
authentication
Network requirements
As shown in
The switch acts as the Stelnet server, adopting publickey authentication and the RSA public key
algorithm.
Figure 81 Network diagram
Figure 81, you can log in to the switch through the Stelnet client (SSH2) that runs on the host.
219